utahjae.blogg.se

The result will be a hard disk image file of the CD. So, if you have room for the data, and the zeroes get truncated that's ok.ĭd if=/dev/hdc of=/home/sam/mycd.iso bs=2048 conv=notrunc The very last part of the drive is usually zeroes. What you want to do is this:ĭd if=/dev/sda3 of=/dev/sda2 bs=4096 conv=notrunc,noerror Now, if you are copying sda3 to sda2, this is different. Mount -o loop /home/sam/smaller_partition.img /mnt/directory cd /mnt/directory cp -r * /mnt/larger_partition_already_partitioned_and_formatted_to_the_size_you_wantĬp has an -r switch for recursive copy. The way around this is to build a partition image file.ĭd if=smaller_partition of=/home/sam/smaller_partition.img If you dd a smaller partition to a larger one the larger one will now be formatted the same as the smaller one and there won't be any space left on the drive. This is because fdisk reads the partition table and df reads the format info. If you are copying a smaller partition to a larger one, the larger partition will read the correct size with: The first 63 sectors of a drive are empty, except sector 1, the MBR. You don't want to tell a drive it is bigger than it really is by writing a partition table from a larger drive to a smaller drive. By doing this, you leave the first 8k bytes (4k*2 bs, bs applies to both seek and/or skip) on each drive untouched.

Seek skips over so many blocks on the output media before writing (sdb). Skip skips input blocks at the beginning of the media (sda). If you are copying sda to sdb, an entire drive with a single partition, sdb being smaller than sda, then you have to do:ĭd if=/dev/sda skip=2 of=/dev/sdb seek=2 bs=4k conv=noerror The only difference between a big partition and a small partition, besides size, is the partition table. You can write a blank disk to a good disk if you get confused. If sdb2 doesn't exist, dd will start at the beginning of the disk, and create it. This feature has inspired the nickname "dd" Data Destroyer.Įxamples: Copy one hard disk partition to another hard disk:ĭd if=/dev/sda2 of=/dev/sdb2 conv=notrunc,noerror Warning!! If you reverse the source and target, you can wipe out a lot of data. The basic command is structured as follows:ĭd if= of= bs=("USUALLY" some power of 2, not less than 512 bytes(ie, 512, 1024, 2048, 4096, 8192, 16384, but can be ANY reasonable number.) skip= seek= conv=. It is a bitstream duplicator for copying data, but can use input or output pipes to another command.